You could use para lock for your potting compound on the strength member, it will soak into your dacron, I have done this with kevlar before. You will need to splay out your dacron to the shape of the cone in your housing, taking it the full length of the cone if required and pot it, you could also put small protection sleeve over your coax and power cores as they pass through the potting, this would help protect them from crushing if a substantial load tension was applied.
While potting this keep your housing vertical and your cable coming straight out the bottom avoiding any bending.
Hopefully a link has appeared below, this will take you a supplier or the manufacturer of paralock. You may even get it from RS!
Hopefully this will help you a bit.
[url http://www.millfield-group.co.uk/millfield-wirelock/other-products/[/url]
While potting this keep your housing vertical and your cable coming straight out the bottom avoiding any bending.
Hopefully a link has appeared below, this will take you a supplier or the manufacturer of paralock. You may even get it from RS!
Hopefully this will help you a bit.
[url http://www.millfield-group.co.uk/millfield-wirelock/other-products/[/url]